Configuring multi-language

The Anywhere Platform supports configuration of the solution so that users can use it in their preferred language or where there is a requirement by law to support more than one language. This capability is provided through the translations editor.

• From the menu, select 'Config Workbench' under the 'Administration' section.

• From the configuration workbench, select 'Translations' from the 'Server Configuration' section.

• Click on Save when done.

• Click on Save when done.

• For the translation engine to translate a word it must be marked with the appropriate token.

• If the token is converted and matched to a corresponding translations, the translated word will be displayed to the user; if not match is found then the original text of the word without the tokens will be displayed instead.

• For the translation engine to pick up a token it must be wrapped in [ T.] , with TOKEN as the word to be translated. There should be no spaces between the [ and the T

• As an example from the table above, [T.PROJECT] will be translated according to the user's preferred language.

• Locate the word and language to be edited.

• Make the change to the word and click on 'Save' to apply the changes.

• Updated translations will immediately take effect for any users that are using the affected language without the need to log out and back in. However there may be a need to refresh the page for any pre-loaded words to be retranslated via the translation engine 

• To remove a word from the translation library click on the 'X' icon to the right of the translation row.

• To remove an entire language from the library click on the 'Remove' link in the column header for the language to be removed.

• A user's preferred language is set on their account profile. Refer to User Accounts for further details.